Table of Contents
Advertisement
Advanced operation
4.16 Color coordinates
About color coordinates:
It is possible to change the color coordinates of your display.
Color coordinates can only be changed on your display when color presets is set to User. Please
refer to
"Color presets", page 33
To change the color coordinates:
1.
Bring up the OSD main menu.
2.
Navigate to the Configuration > Calibration > Color Settings menu.
3.
Enter the Color Definition submenu.
4.
Select Color Coordinates and confirm.
5.
Enter the x and/or y submenu.
6.
Set the coordinate value for x and/or y as desired and confirm.
4.17 Viewing modes
About viewing modes
The Coronis Uniti can be used in two viewing modes:
•
Diagnostic: This mode provides the full calibrated luminance and is intended for using the display for
diagnostic purposes.
•
Text: In this mode, the luminance is reduced to approximately half of the luminance. This is intended for
using the display with office applications such as word processing.
Please note that text mode is not persistent. Once powered off, the display will restart in diagnostic mode.
The diagnostic mode should always be selected when the Coronis Uniti is intended to be used for
screening and diagnosis.
To select a viewing mode
1.
Bring up the OSD main menu.
2.
Navigate to the Configuration > Calibration menu.
3.
Enter the Viewing Mode submenu.
4.
Select Diagnostic/Text as desired and confirm.
To quickly switch the viewing mode without having to enter the OSD menu, touch the left and right
key at the same time during normal operation.
4.18 Display functions
About display functions
Native, uncorrected panels will display all grayscale/color levels with luminance increments that are not
optimal for crucial diagnostic information. Studies have shown however, that in medical images certain
grayscale/color parts contain more diagnostic information then others. To respond to these conclusions,
34
K5902079 /11
Coronis Uniti
to do this.
Advertisement
Table of Contents
