Table of Contents
Advertisement
Basic Installation Procedures
Step 8: Testing Your Installation
ELECTRICAL SHOCK HAZARD
Do not use the INVERTER ENABLE button on the Freedom
SW-RVC to de-energize the unit. This button and buttons on
optional accessories, such as the RV-C system device
controller, if available, do not disconnect DC or AC power
sources to the Freedom SW-RVC.
Failure to follow these instructions can result in death or serious
injury.
51
WARNING
There are several tests to be performed for testing your
installation. These tests will verify that:
the Freedom SW-RVC works in invert mode
n
the Freedom SW-RVC works in charge mode
n
the Freedom SW-RVC works in AC bypass mode
n
If the test fails at any point, go to Step 7: Performing Checks Prior
to Initial Start-Up on page 50 and go through the checklist again to
check the installation. Then perform the test again. If the test fails
again, see the troubleshooting section in the Owner's Guide
(document number: 975-1056-01-01).
Figure 13 Freedom SW-RVC Front Panel
RV-C INTERFACE
STACKING
CLEAR FAULT
INVERTER
RESET
ENABLE
INVERTER
ENABLED
AC IN
FAULT
GEN
CHARGING WARNING
SUPPORT
Freedom SW-RVC Installation Guide
Advertisement
Table of Contents
