Table of Contents
Advertisement
Safety Information
ELECTRIC SHOCK HAZARD
• Do not expose the Freedom SW-RVC to rain, snow, or spray water.
• Do not operate the inverter/charger if it has received a sharp blow, been
dropped, has cracks or openings in the enclosure including if the AC terminal
cover has been lost, damaged, or will not close, or otherwise damaged in any
other way.
• Do not disassemble the inverter/charger. Internal capacitors remain charged
after all power is disconnected.
• Disconnect both AC and DC power from the inverter/charger before
attempting any maintenance or cleaning or working on any circuits connected
to the inverter/charger. The INVERTER ENABLE button on the front panel
does not function like a power switch that energizes or de-energizes the unit
arbitrarily. When AC and DC power sources are connected and present, the
unit is always energized.
• Do not operate the inverter/charger with damaged or substandard wiring.
Make sure that all wiring is in good condition and is not undersized.
Failure to follow these instructions will result in death or serious
injury.
NOTE: Turning the inverter/charger to Standby mode using the
INVERTER ENABLE button on the front panel will not reduce an
electrical shock hazard.
6
DANGER
FIRE AND BURN HAZARD
• Do not cover or obstruct the air intake vent openings and/or install in a zero-
clearance compartment.
• Do not use transformerless battery chargers in conjunction with the
inverter/charger due to overheating.
Failure to follow these instructions will result in death or serious
injury.
DANGER
Freedom SW-RVC Installation Guide
Advertisement
Table of Contents
