Bypass; Multi-Car Operation; Horn Honk Timing - Autostart AS-2775 Installation Manual

To set the system to Ready Mode:
If Ready Mode is enabled by remote
1. Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector is in the
neutral position.
2. With the engine already running, apply the
parking brake once and release the brake
pedal.
Make sure to release the brake pedal.
3. Within 20 sec. of engaging the parking
brake, press and hold
on the transmitter.
START
The parking lights will flash 3 times
quickly and remain lit.
4. Remove the key: the engine will continue running.
5. Exit the vehicle and close all doors, hood and trunk.
6. Press for approx. 1 second either:
a.
LOCK
b.
UNLOCK
c.
START
Note: The vehicle will also enter Ready Mode once the engine run time expires.

Bypass

Remote starters of this series offer three possibilities for bypass D2D: they are compatible with
Trilogix, ADS and Fortin bypasses (Trilogix by default).

Multi-car Operation

This option allows the owner of two vehicles, both equipped with the same Remote Car Starter
model, to control both systems with a single remote control. To control the second vehicle,
simultaneously press the
Note: The remote control must be configured for second car operation by the installer.
Press
TRUNK
Press
TRUNK
Press
TRUNK
Press
TRUNK
Press
TRUNK

Horn Honk Timing

Follow these steps to program horn confirmation:
1. Enter programming mode (see on page 15)  the parking lights will stay on for up to 20
seconds.
2. Press and hold the brake pedal, then simultaneously press the
the horn will chirp 5 times.
3. Release the brake pedal.
4. To change the timing:
a. To increase the Horn pulse by 3 ms, press the
b. To decrease the pulse by 3 ms, press the
c. To increase the pulse by 10 ms, press the
d. To decrease the pulse by 10 ms, press the
P. 28
, or
LOCK UNLOCK
to lock the doors and shut down the engine;
to unlock the doors and shut down the engine;
to shut down the engine without affecting the doors.
button and the button of the function you wish to use.
TRUNK
+ buttons simultaneously: ....
LOCK
+ simultaneously:..............
UNLOCK
+ simultaneously:.................
START
+ simultaneously:...................
STOP
+ simultaneously for 3 sec:..
START
If Ready Mode is enabled by handbrake
2. With the engine already running, apply the
parking brake twice and release the brake
pedal.
Make sure to release the brake pedal.
The parking lights will flash 3 times
quickly and remain lit.
Skip to step 4.
LOCK
UNLOCK
START
STOP
Cold Weather Mode
UNLOCK
LOCK
button.
UNLOCK
button.
START
button.
TRUNK
-
buttons 
and
START
button.
Installation Guide