Horn Honk Timing; Testing - Autostart AS-1585 SH Installation Manual

The Parking Light output from the Remote Car Starter will activate when the
vehicle starts and shut off once a Tach signal is detected.
4. Press the Brake Pedal and keep it down until you hear the Parking Lights Output
flash 5 times.
5. Shut down the Engine. Tach Programming is now complete.

Horn Honk Timing

Follow these steps to program Horn Confirmation:
1. Ensure that the Hood is up and that the Ignition is
Hold the Hood Pin-switch down for 4 seconds.
Release the Pin-switch. The Parking Lights will come on.
While the Parking Lights are on, immediately push and release the
Pin-switch again. The Parking Lights will stay on for up to 20 seconds.
2. Press and hold the Brake Pedal, then simultaneously press the
buttons on the Transmitter – the Horn will honk 5 times.
3. Release the Brake Pedal.
4. To change the timing:
a. To increase the Horn pulse by 3 ms, press the
b. To decrease the pulse by 3 ms, press the
c. To increase the pulse by 10 ms, press the
d. To decrease the pulse by 10 ms, press the
5. To save the new settings: press
settings have been saved.
Otherwise close the Hood to cancel the changes.
For each timing change, the Horn will honk with the new settings, except in the
following cases:
When the lower limit of 5 ms is reached, there will be a 1/4-sec. honk.
When the upper limit of 200 ms is reached, there will be a 3/4-sec. honk.
A system reset will set the Remote Car Starter back to the default values: 30 ms.

Testing

Before putting back the vehicle together, it is recommended to check that the system
operates properly. The following testing procedures should be used to verify proper
installation and operation of the system. Before testing, make sure that all connections are
soldered and that the unit is plugged in.
Make sure the Remote Car Starter properly enters and exits Ready Mode:
Setting the system to Ready Mode
1. Ensure that all the Doors are closed and that the Gear Shift Lever is in the
position.
2. With the Engine already running, apply the Parking Brake and release the Brake
Pedal.
Make sure to release the Brake Pedal.
3. Within 20 sec. push
The Parking Lights will flash 3 times quickly and remain lit.
AS-1585 SH Installation Guide
Table 6: Automatic Tach Programming
LOCK
UNLOCK
START
TRUNK
and
LOCK UNLOCK
Table 9: Adjusting Honk Duration
, or on the Transmitter.
LOCK UNLOCK START
.
OFF
and
UNLOCK
button.
button.
or button.
STOP
button.
. If 3 honks are returned the new
NEUTRAL
P. 17
START