After the location is found, attach the mounting base to the area using the supplied hardware.
Figure 2.1 - Example of Bracket installation (CP180 on the left side and CP300 on the right side)
2.2
FLUSH MOUNTING
The CP180/CP180i and CP300/CP300i are supplied with a flush mounting template for the
cutout hole and screw holes required to install the GPS Chart Plotter.
Before drilling holes make sure there is enough room to mount the GPS Chart Plotter and there
are no obstructions.
Page 14
NOTE
Figure 2.2 - Example of CP180 Flush installation
GPS Chart Plotters