76
EN
Sleeping operation mode
•
Press the SLEEP button, the
sleeping indicator light of indoor
unit flashes on.
•
After the setting of sleeping mode,
the cooling operation enables the
set temperature to increase 1 °C
after 1 hour and another 1 °C auto-
matically after 1 hour.
•
After the setting of sleeping mode,
the heating operation enables the
set temperature to drop 2°C after
1 hour and another 2°C automa-
tically after 1 hour.
•
The air-conditioner runs in sleeping
mode for 7 hours and stops auto-
matically.
Note: Press the MODE button or ON/OFF
button, the remote controller clears
sleeping mode away.
ATTENTION
•
Aim the remote controller towards
the receiver on the air-conditioner.
•
The remote controller should be
within 8 meters away from the
receiver.
•
No obstacles between the remote
controller and receiver.
•
Don't drop or throw the remote
controller.
•
Don't put the remote controller
under the forceful sunrays or heating
facilities and other heating sources.
•
Use two 7# batteries,don't use the
electric batteries.
•
Take the batteries out of remote
controller before stop its using for long.
•
When the noise of transmitting
signal can't be heard indoor unit
or the transmission symbol on
the display screen doesn't flare,
batteries need be replaced.
•
If reset phenomenon occurs on
pressing the button of the remote
controller,the electric quantity is
deficient and new batteries need
to be substituted.
•
The waste battery should be dis-
posed properly.