Table of Contents
Advertisement
1
15 cm
1 2 c m
2,3 m
1 2 c m
60 cm
3 0
c m
2
9
16
6 0
c m
EN
EN
S E L E C T
T H E
SELECT
LOCATION
THE BEST LOCATION
Indoor unit
1
Indoor unit 1
•
There should not be any heat
source or stream near the unit.
•
There is no heating and steaming
source nearby.
•
There should not be any obstacles
blocking the air circulation.
•
No obstacles for installing position
nearly.
•
A place where air circulation in the
room is good.
•
A place where drainage can be
•
Keep good air circulation.
easily done.
•
A place where noise prevention is
taken into consideration.
•
Convenient to adoptmeasures
•
Do not install the unit near the door
to reduce noises.
way.
•
Ensure the spaces indicated by
arrows from the wall, ceiling, fence
•
Don't install them near the door
or other obstacles.
way.
•
There should not be any direct
•
Make sure to have the distance
sunlight. If unavoidable, sunlight
specified in the picture between
prevention should be taken into
the ceiling, wall, furniture and other
consideration.
obstacles.
Outdoor unit
•
2 meters high above the floor.
2
•
If an awning is built over the unit to
prevent direct sun sight or rain, be
careful that heat radiation from the
Outdoor unit 2
condenser is not obstructed.
•
In case that you put up a canopy
to protect it from rains and sunrays,
pay attention not to cause any obs-
•
There should not be any animal or
tacles for the heating dispersion
plant which could be affected by hot
for the condenser.
air discharged.
•
Keep the spaces indicated by arrow
•
Don't grow animals or plants near
from wall ceiling, fence or other
the installation location for the cold
obstacles.
and hot air out will affect them.
•
Do not place any obstacles which
may cause a short circuit of the
discharged air.
•
Make sure to have the distance
specified in the picture between
ceiling, wall, furniture and other
obstacles.
•
Don't install it near from heating
source and inflammable air.
•
The installation base and suppor-
ting frame should be strong and
secure. The machine should be
at plane surface.
B E S T
Advertisement
Table of Contents
