Keysight Technologies N9310A Quick Start Manual page 10

Quick Start Guide
Preparation for Use
Turn On the Signal Generator
N O T E
8
Follow this procedure to power on the signal generator:
1 Press the power switch
LED will light and the signal generator is in standby mode.
2 Press the standby switch
LED will light.
Self- initialization takes about 30 seconds; the signal
generator then defaults to the menu mode with the
maximum frequency of 3 GHz and minimum amplitude of
127 dBm, then the signal generator is ready for your
–
current use. After power on, let the signal generator warm
up for 45 minutes for stabilization.
The front panel switch is a standby switch only; it is not a power
switch. To disconnect the signal generator from the line power, shut
off the power switch on the rear panel.
on the rear panel. The orange
on the front panel. The green