Grizzly G0513 Series Owner's Manual page 27

20. Install fence on left-hand side of blade.
21. Place fence flush against bandsaw blade
(see Figure 30).
Figure 30. Fence flush with blade.
22. Loosen pointer adjustment nut (see Figure
31) and set pointer in line with "0" on mea-
surement scale on rail.
Figure 31. Calibrating fence pointer
(adjustment nut out of view).
23. Re-tighten pointer adjustment nut.
G0513 Series Bandsaws (Mfd. Since 08/22)
Pointer Nut
Pointer
Models G0513A40,
G0513X2BF
24. Place 8mm flat washer on locking handle
(see Figure 32), slide it through hole in fence,
then thread moving plate onto end of locking
handle threads.
25. Slide resaw fence over moving plate, as
shown in Figure 32, so moving plate fits
inside channel of resaw fence, then tighten
locking handle.
Resaw Fence
Locking
Handle
Figure 32. Attaching resaw fence.
Locking Handle
Figure 33. Resaw fence properly installed.
G0513X2 &
Moving
Plate
Resaw
Fence
-25-