Aligning Wheels - Grizzly G0513 Series Owner's Manual

Aligning Wheels

Components and Hardware Needed:
56" Long 2x4 ..................................................... 1
Tools Needed:
Hex Wrenches 4, 6mm .................................1 Ea
Wrench 13mm ................................................... 1
Tape Measure .................................................... 1
Coplanarity Gauge (see Figure 113) ................. 1
Straightedge ........................................................
Fine Ruler .......................................................... 1
Wheel alignment is one of the most critical factors
for optimal performance from your bandsaw.
Heat, vibration, wandering, blade wear, tire wear,
and overall bandsaw wear are considerably
decreased when the wheels are properly aligned
or "coplanar."
Coplanar wheels automatically track the blade
by balancing it on the crown of the wheel. This is
known as coplanar tracking.
Checking Coplanarity
1. Make the "Coplanarity Gauge" shown in
Figure 113.
Note: For best results, straighten the 2x4
with a jointer before cutting.
2. DISCONNECT MACHINE FROM POWER!
3. Remove the fence and open both wheel
covers.
4. Adjust the blade guides away from the blade,
loosen blade tension, remove the table insert
and pin, then remove the blade.
5. Remove the table.
6. Re-install the blade, making sure the blade
guides and support bearings are away from
the blade, then tighten the blade to the ten-
sion that will be used during operation.
7.
Place your coplanarity gauge up against both
wheels in the positions shown in Figure 114.
G0513 Series Bandsaws (Mfd. Since 08/22)
Qty
Figure 113. Dimensions of coplanarity gauge.
Tracking
Knob
Adjustment
Hub
Figure 114. Checking for coplanarity.
3- ⁄ "
1
2
17"
56"
22"
1- ⁄ "
1
2
17"
Side View
Coplanarity
Gauge Positions
Gauge
Wheels
-71-