Section 6: Maintenance; Schedule; Wheel Brush; Cleaning & Protecting - Grizzly G0513 Series Owner's Manual

SECTION 6: MAINTENANCE

To reduce risk of shock or
accidental startup, always
disconnect machine from
power before adjustments,
maintenance, or service.

Schedule

For optimum performance from this machine, this
maintenance schedule must be strictly followed.
Ongoing
To minimize your risk of injury and maintain proper
machine operation, shut down the machine imme-
diately if you ever observe any of the items below,
and fix the problem before continuing operations:
• Loose mounting bolts.
• Worn or damaged saw blade.
• Worn or damaged wires.
• Check/clean wheel brush.
• Clean/protect table surface.
• Check lubrication points.
• Any other unsafe condition.
Monthly Check
• V-belt tension, damage, or wear.
• Clean/vacuum dust buildup from inside cabi-
net and off motor.

Wheel Brush

The bandsaw is equipped with a lower wheel
brush to keep saw dust from building up on the
tire. The brush should be checked daily and
cleaned when it becomes dirty.
There is an adjustment bracket that allows the
brush to be adjusted for bristle wear (refer to
Adjusting Wheel Brush on Page 68 for detailed
instructions).
G0513 Series Bandsaws (Mfd. Since 08/22)
Cleaning &
Protecting
Cleaning the bandsaw is relatively easy. Vacuum
excess wood chips and sawdust, and wipe off the
remaining dust with a dry cloth. If any resin has
built up, use a resin dissolving cleaner to remove
it.
Protect the unpainted cast iron surfaces on the
table by wiping it clean after every use—this
ensures moisture from wood dust does not remain
on bare metal surfaces. Keep the table rust-free
with regular applications of products like G96
Gun Treatment, SLIPIT
Page 58 for more details).

Lubrication

An essential part of lubrication is cleaning the
components before lubricating them. This step
is critical because dust and chips build up on
lubricated components, which makes them hard
to move. Simply adding more grease to built-
up grime will not result in smooth moving parts.
Clean the components in this section with an oil/
grease solvent cleaner or mineral spirits before
applying lubrication.
All bearings are sealed and permanently lubri-
cated. Leave them alone until they need to be
replaced.
Blade Post Rack & Pinion
Lubrication Type ... T26419 or NLGI#2 Equivalent
Amount .................................................Thin Coat
Frequency .......................................... As Needed
To lubricate the blade post rack and pinion:
1. DISCONNECT MACHINE FROM POWER!
2. Lower blade guides until they reach the table.
, or Boeshield T-9 (see
® ®
-61-
®