System Operation
Ethernet Info Screen
1.
From the System Information Menu, press 5 to access the Ethernet Information.
t
AlarmNet Info Screen
1.
From the System Information Menu, press 6 to access the AlarmNet Information.
2.
Cell Strength: 0 to 100%
3.
Status: Registered/Not Registered
AlarmNet Temp Pin
1.
Press 7 from the System Information Menu to access the AlarmNet Temp Pin. This is used in case the FACP is replaced
on the CCP.
10.5 Operation Mode Behavior
The control panel can be in one or more of seven conditions at any given moment:
•
Normal
Table 10.1describes the behavior of the panel in each of the condition modes.
When you view the LCD, the screen will display FIRE for the "Fire System", CO for the "CO System". The highest priority
event will display first and include the Event Count (see Figure ).
Press the down arrow key to view the location and type of the alarm, supervisory or trouble. If the panel is programmed to the
Auto Display Event, the information describing the highest priority active event will display on the first two lines.
The 3 and 4th line will show the status of which event types are active for each system (fire and CO). The Auto Display Event
activates after two minutes of the annunciator inactivity.
This Screen will display when more than 3 Event Types are active.
110
•
Alarm •
Prealarm
Figure 10.4 Highest Priority Event Display
IFP-75/IFP-75HV Installation/Operation Manual — P/N LS10147-001SK-E:D 06/25/2021
•
Supervisory •
Trouble
Figure 10.5 Event Types Screen
Operation Mode Behavior
•
Silenced
•
Reset