Current Output Isolation (High Or Low Terminal); Voltage From The Current Terminals (Dc And Sine Wave Only); Range Limits And Impedances; Voltage From Current Terminals - Fluke 6003A Operator's Manual

6003A
Operators Manual

Current Output Isolation (high or low terminal)

450 V peak maximum above earth ground. The current output terminals must only be energized by the Product Voltage
output terminals.

Voltage from the Current Terminals (DC and Sine Wave Only)

Range Limits and Impedances

Source Impedance
Minimum load impedance to maintain specification

Voltage from Current Terminals

Range
1.000 mV to
20.000 mV
20.001 mV to
330.000 mV
0.33001 V to
5.00000 V

Voltage from Current Terminals, Distortion

<0.1 %, 15 Hz to 200 kHz bandwidth

Phase and Power Factor (Sine Wave Outputs)

Phase range
Frequency range
Phase resolution
Power factor range
Power factor resolution
Power factor accuracy

Current to Voltage Phase

Current Output
0.008 A to 0.099999 A
0.1 A to 10 A
10.0001 A to 30 A
≤40 % of range. There are three voltage ranges, 20 mV, 330 mV and 5 V.
For voltage from the current terminals, use the 0.1 A to 10 A phase specification for > 40 % of range and 0.008 A to 0.099999 A for
1-10
Range
Frequency
dc
15 Hz to 400 Hz
dc
15 Hz to 400 Hz
dc
15 Hz to 400 Hz
For All Voltage Outputs (1 V to 600 V)
15 Hz to 70 Hz
70 Hz to 400 Hz
400 kHz to 1 kHz
15 Hz to 70 Hz
70 Hz to 400 Hz
400 kHz to 1 kHz
15 Hz to 70 Hz
70 Hz to 400 Hz
400 kHz to 1 kHz
1.000 mV to 20.001 mV to
20.000 mV 330.000 mV
1 Ω
25 kΩ 25 kΩ
1-Year Specification, Tcal 2°C ±(% of output + V)
0.05
0.05
0.05
0.05
0.05
0.05
0.0 ° to 359.99 °
15 Hz to 1 kHz
0.01 °
-1 to +1 (Lead, Lag)
0.001
(1 - cos (ϕ+dϕ)/cos ϕ) where ϕ is the phase in degrees and
dϕ is the phase specification in degrees.
1-Year Specification, Tcal ±2 °C
Frequency
0.05 °
0.1 °
0.4 °
0.01 °
0.1 °
0.4 °
0.05 °
0.1 °
0.4 °
0.33001 V to
5.00000 V
1 Ω 18 Ω
450 kΩ
20 µV
20 µV
200 µV
200 µV
1 mV
1 mV