Advertisement
Instructions
This terminal holder connects the INTERMEC
Computers to the 4820 Printer. Perform these instructions, in the order given, to
ensure reliable operation of this equipment.
1. Test the printer and old terminal holder.
2. Remove the old terminal holder.
3. Connect the new terminal holder.
4. Orient and test the new terminal holder.
Terminal Holder Installation Kit
"
"
"
"
"
"
"
"
"
"
" NOTE:
These items are required for regulatory compliance to prevent EMI interference.
Tools Required
"
"
"
"
Customer Support Center
Should you need assistance, the Intermec Customer Support Center (technical
support) telephone number is 800-755-5505 (U.S.A. or Canada) or 425-356-1799.
The facsimile number is 425-356-1688. Email is support@intermec.com.
If you email or fax a problem or question include the following information in
your message: your name, your company name and address, phone number and
email to respond to, and problem description or question (the more specific, the
better). If the equipment was purchased through a Value-Added Reseller please
include that information.
2
4820 Printer Terminal Holder Upgrade Instructions
Terminal Holder Assembly
Four screws, 8-32 x 1.25" (flathead)
I/O extension cable
13-conductor shielded flex cable
Ferrite bead
Double-sided tape for ferrite bead (1.25")
Double-sided tape for printer frame (3–4")
13x16 plastic bag
3x4 plastic bag
Terminal holder upgrade instructions
#1 Phillips screwdriver with a 9.5" (24 cm) shaft
Needle-nosed pliers
Wire cutter
Loctite
R
425 (orderable as a separate line item — P/N: 901-386-002)
R
600 Series and 700 Series
Various
P/N: 801-115-000
P/N: 226-329-001
P/N: 321-560-001 * See note
P/N: 309-369-001 * See note
P/N: 906-011-002 * See note
P/N: 906-029-001
P/N: 901-250-004
P/N: 901-250-003
P/N: 962-018-012
Advertisement
