Advertisement
Install Flex Cables and Pivot Frame
" NOTE:
See Figure 8 on page 7 for guidelines.
1. Install the new 13-conductor shielded flex cable to the back of the pivot
2. Attach the two flex cables to the printer control panel and lower the pivot
3. Install the lid back onto its hinges and close into place.
Secure New Terminal Holder
Four 8-32 x 1.25" flathead screws are included in this kit. Loctite 425 is required
to secure these screws.
1. Squeeze a small drop of Loctite 425 onto the tip of each screw, enough to
2. Insert each screw into a hole and tighten into place. Use a soft cloth to
3. Go to page 12 to orient and test the new terminal holder.
frame and align the pivot frame, with its 14-conductor flex cable, back onto
its hinges.
frame into place.
cover 3–4 threads.
wipe away excess threadlocker.
Screws
Aligning Screws for New Terminal Holder
Figure 15
4820 Printer Terminal Holder Upgrade Instructions
11
Advertisement
