Advertisement
Upgrade the Fixed-Mount Printer
1. Use the Phillips screwdriver to remove the blank cover plate. Save the
2. Remove the old terminal holder, pull the slide retainer back to reveal the
Install I/O Extension Cable
1. Detach the old terminal holder ground cable from the printer ground cable.
2. Detach the old terminal holder ribbon cable from the printer control panel.
3. Align the I/O extension cable along the same path as the old ribbon cable.
4
4820 Printer Terminal Holder Upgrade Instructions
cover plate, its four screws, and their white spacers for future use.
two concealed screws. Discard all four screws.
3
Detaching Cover Plate and Terminal Holder
Dislodge the ribbon cable from the printer frame, and pull the ribbon cable
out through the slot. Replace the 3–4" double-sided tape on the printer
frame, if needed.
Insert the I/O extension cable into the control panel. Press the I/O exten-
sion cable onto the tape inside the printer frame.
Ribbon cable
Following Ribbon Cable Path
1. Slide retainer
2. Terminal holder
3. Blank cover plate
Figure 2
Figure 3
1
2
Slot in printer frame
Advertisement
