Advertisement
Secure New Terminal Holder
Four 8-32 x 1.25" flathead screws are included in this kit. Loctite 425 is required
to secure these screws.
1. Squeeze a small drop of Loctite 425 onto the tip of each screw, enough to
2. Use a soft cloth to wipe away excess threadlocker.
3. Go to page 12 to orient and test the new terminal holder.
8
4820 Printer Terminal Holder Upgrade Instructions
cover 3–4 threads, then insert each screw into a hole and tighten into place.
2
1
Aligning Screws with New Terminal Holder
1. New terminal holder
2. Screws
Figure 10
Advertisement
