Table of Contents
Advertisement
Interval
Where?
in case of need
INFORMATION
The spindle bearing is lifetime-lubricated. It is not necessary to lubricate it again.
EN
DH35V
46
What?
How?
Any unusual rattling noises can be eliminated by regreasing.
The sleeve (1) moves downwards or upwards with the toothed
spindle (2) in the fixed driven sleeve (3) during drill feed. The
noises are caused by the necessary clearance between the two
toothings of the sleeve and spindle. The grease in the delivery
condition may have been used up.
2
1
Img. 6-6:
Regreasing is carried out from above via the spindle drive. Apply
grease at the visible toothed area of the spindle. It is
recommended to use a grease which can remain permanently
inside the toothing. The grease "Staburag NBU 30 PTM" from
Klüber is recommended and has proved to be a successful
assembly grease for clearance fits.
Translation of original instruction
3
2
3
Maintenance
Version 1.0.2 - 2020-07-06
Advertisement
Table of Contents
