GARDASOFT RT 20 Series User Manual page 59

IP
Input trigger (set using the RP command)
FL
Flags (set using the RE command)
CS
Rating of the light (after SafeSense has suc-
cessfully completed sensing the light)
RA
Rating of the light (set using the VL command).
When using Ethernet, use the following forms of the ST
command:
ST0
Reports the general settings. A typical output is:
TM 1, TP 20.00ms
STc
Where:
c = the input channel (1 to 2, 4, or 8 depending on model).
This reports the settings for a single channel.
Simulate an Input Trigger
TRc
Where:
c = the input channel (1 to 2,4 or 8, depending on model).
This simulates a trigger pulse. If the channel is in pulse mode it
pulses the output once.
Enable Ethernet Messages
GTm
Where:
m = 0 to disable Ethernet messages, or
m = 1 to enable Ethernet messages.
When Ethernet messages are enabled, any error reports are sent
to the most recent UDP or TCP address from which a command
has been received. Messages are of the form:
Evtc,e
Where:
= the channel number (1 to 2,4 or 8), or 0 for no channel
c
= event value (see
e
RTxxx LED lighting controllers - User Manual
Section 13.5, Event
— 59 —
codes).