Other Programming; Registering A Unit - Panasonic KX-TGM470C Operating Instructions Manual

2
MbN: Select the desired setting. a
MSAVEN
R If you select "Off", press MOFFN to
exit.
3
Enter the desired hour and minute you
wish to start this feature.
4
*: Select "AM" or "PM". a MOKN
5
Enter the desired hour and minute you
wish to end this feature.
6
*: Select "AM" or "PM".
7
MSAVEN a MOFFN
Changing the start and end time
1
For handset: MMENUN#237
For base unit (using a handset):
MMENUN#*237
2
Continue from step 3, "Turning night
mode on/off", page 48.
Selecting groups to bypass night
mode
1
For handset: MMENUN#241
For base unit (using a handset):
MMENUN#*241
2
MbN: Select the desired groups. a
MSELECTN
R " " is displayed next to the selected
group numbers.
R To cancel the selected group:
MbN: Select the group. a Press
MSELECTN again. "
3
MSAVEN a MOFFN

Other programming

Changing the handset
name
The default handset name is "Handset 1" to
"Handset 6". You can customize the name
of each handset ("Bob", "Kitchen", etc.). This is
useful when you make intercom calls between
handsets. To display the handset name in
For assistance, visit www.panasonic.ca/english/support
TGM470_490C(en)_0805_ver403.pdf
standby mode, turn on the handset name
display feature (page 49).
1
MMENUN#104
2
Enter the desired name (10 characters
max.). a MSAVEN a MOFFN
Displaying the handset
name
You can select whether or not the handset
name is displayed in standby mode. The
default setting is "Off".
1
MMENUN#105
2
MbN: Select the desired setting. a
MSAVEN a MOFFN

Registering a unit

Operating additional units
Additional handsets
Up to 6 handsets can be registered to the
base unit.
Important:
R See page 5 for information on the available
model.
Registering a handset to
the base unit
" disappears.
The supplied handset and base unit are
pre-registered. If for some reason the handset
is not registered to the base unit, re-register
the handset.
1
Handset:
MMENUN#130
2
Base unit:
Press and hold MLOCATOR/INTERCOMN
for about 5 seconds.
R If all registered handsets start ringing,
3
Handset:
Press MOKN, then wait until a long beep
sounds.
49
Programming
press MLOCATOR/INTERCOMN again
to stop, then repeat this step.
2021/08/05
49
10:23:30