Table of Contents
Advertisement
Programming
Baby monitor sensitivity
You can adjust the sensitivity of the baby
monitor. Increase or decrease the sensitivity to
adjust the sound level needed to trigger the
baby monitor feature.
R This feature cannot be set during a
monitoring call.
Handset
1
Press MMENUN on the handset being
monitored.
2
MbN: "Sensitivity level" a
MSELECTN
3
MbN: Select the desired setting. a
MSAVEN a MOFFN
Answering the baby monitor
n When monitoring with a unit:
Handset: Press M
Base unit: Press M
If you want to respond from the monitoring
unit, press MMUTEN.
R The monitoring unit will answer calls
automatically when the auto intercom
feature is set to "On" (page 20).
Note:
R If you receive an outside call when
communicating with the monitored handset,
the interrupt tone sounds.
– To answer the call with the handset,
press MOFFN, then press M
– To answer the call with the base unit,
press MZN 3 times.
*1
If MMUTEN is pressed, press MZN 2
times.
n When monitoring from outside:
Answer the call.
If you want to respond from your monitoring
phone, press #1 using tone dialing.
You can turn off the baby monitor feature
by pressing #0.
Note:
R The unit disconnects the call automatically
after 2 minutes.
For assistance, please visit http://shop.panasonic.com/support
38
TGF242_TG3752USA(en)_1107_ver021.pdf 38
Other programming
Changing the handset name
The default handset name is "Handset 1" to
"Handset 6". You can customize the name
of each handset ("Bob", "Kitchen", etc.). This is
useful when you make intercom calls between
handsets. To display the handset name in
standby mode, turn on the handset name
display feature (page 38).
1
2
Displaying the handset name
N to answer a call.
You can select whether or not the handset
N to answer a call.
name is displayed in standby mode. The
default setting is "Off".
1
2
Registering a unit
N.
Operating additional units
*1
Additional handsets
Up to 6 handsets can be registered to the
base unit.
Important:
R See page 4 for information on the available
Registering a handset to the
base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
Handset
MMENUN#104
Enter the desired name (10 characters
max.). a MSAVEN a MOFFN
Handset
MMENUN#105
MbN: Select the desired setting. a
MSAVEN a MOFFN
model.
2016/11/07 11:49:49
Advertisement
Table of Contents
