Other Programming; Registering A Unit - Panasonic KX-TGF943 Operating Instructions Manual

Programming
– To answer the call with the base unit,
press MSP-PHONEN 3 times.
*1 If MMUTEN is pressed, press
MSP-PHONEN 2 times.
n When monitoring from outside:
Answer the call.
If you want to respond from your monitoring
phone, press #1 using tone dialing.
You can turn off the baby monitor feature
by pressing #0.
Note:
R The unit disconnects the call
automatically after 2 minutes.

Other programming

Changing the handset name
The default handset name is "Handset 1" to
"Handset 6". You can customize the name
of each handset ("Bob", "Kitchen", etc.). This is
useful when you make intercom calls between
handsets. To display the handset name in
standby mode, turn on the handset name
display feature (page 48).
Handset
1
MMENUN#104
2
Enter the desired name (10 characters
max.). a MSAVEN a MOFFN
Displaying the handset name
You can select whether or not the handset
name is displayed in standby mode. The
default setting is "Off".
Handset
1
MMENUN#105
2
MbN: Select the desired setting. a
MSAVEN a MOFFN
For assistance, please visit http://shop.panasonic.com/support
48
TGF94x(en)_1007_ver014.pdf
*1

Registering a unit

Operating additional units
Additional handsets
Up to 6 handsets can be registered to the
base unit.
Important:
R See page 4 for information on the available
Registering a handset to the
base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
is not registered to the base unit, re-register
the handset.
1
2
3
Deregistering a handset
A handset can cancel its own registration to
the base unit, or other handsets registered to
the same base unit. This allows the handset to
end its wireless connection with the system.
1
2
3
48
model.
Handset:
MMENUN#130
Base unit:
Press and hold MLOCATORN for about 5
seconds.
R If all registered handsets start ringing,
press MLOCATORN again to stop, then
repeat this step.
Handset:
Press MOKN, then wait until a long beep
sounds.
Handset
MMENUN#131
R All handsets registered to the base unit
are displayed.
MbN: Select the handset you want to
cancel. a MSELECTN
MbN: "Yes" a MSELECTN a MOFFN
2022/10/07 15:47:33