Panasonic KX-TGM470C Operating Instructions Manual page 66

Useful Information
Problem
I fully charged the batteries, but
– still flashes,
– is displayed, or
– the operating time seems to
be shorter.
Making/answering calls, intercom
Problem
is displayed.
Noise is heard, sound cuts in
and out.
The handset does not ring.
The base unit does not ring.
I cannot make a call.
I cannot make long distance
calls.
I cannot use voice paging.
For assistance, visit www.panasonic.ca/english/support
66
TGM470_490C(en)_0805_ver403.pdf
Cause/solution
R Clean the battery ends (
with a dry cloth and charge again.
R It is time to replace the batteries (page 13).
Cause/solution
R The handset is too far from the base unit. Move closer.
R The base unit's AC adaptor is not properly connected.
Reconnect AC adaptor to the base unit.
R The handset is not registered to the base unit. Register it
(page 49).
R You are using the handset or base unit in an area with
high electrical interference. Re-position the base unit and
use the handset away from sources of interference.
R Move closer to the base unit.
R If you use a DSL/ADSL service, we recommend
connecting a DSL/ADSL filter between the base unit and
the telephone line jack. Contact your DSL/ADSL provider
for details.
R The ringer volume is turned off. Adjust the ringer volume
(page 32, 43).
R Night mode is turned on. Turn it off (page 48).
R The ringer volume is turned off by pressing and holding
0 ( ). Press and hold 0 (
(page 32).
R The ringer volume is turned off. Adjust the ringer volume
(page 32, 43).
R Night mode is turned on. Turn it off (page 48).
R The ringer volume is turned off by pressing MRINGER
OFFN. Press MRINGER OFFN again to turn it on (page 32).
R The dialing mode may be set incorrectly. Change the
setting (page 22).
R Make sure that you have long distance service.
R You cannot use voice paging if other units are in use.
66
, ) and the charge contacts
) again to turn it on
2021/08/05 10:23:31