Other Programming; Registering A Unit - Panasonic KX-TGD810 Operating Instructions Manual

Answering the baby monitor
n When monitoring with a handset:
Press M N to answer a call.
If you want to respond from the monitoring
handset, press MMUTEN.
R The monitoring handset will answer calls
automatically when the auto intercom
feature is set to "On" (page 19).
Note:
R If you receive an outside call when
communicating with the monitored
handset, the interrupt tone sounds. To
answer the call, press MOFFN, then press
M N.
n When monitoring from outside:
Answer the call.
If you want to respond from your monitoring
phone, press #1 using tone dialing.
You can turn off the baby monitor feature
by pressing #0.
Note:
R The unit disconnects the call
automatically after 2 minutes.

Other programming

Changing the handset name
The default handset name is "Handset 1" to
"Handset 6". You can customize the name
of each handset ("Bob", "Kitchen", etc.). This is
useful when you make intercom calls between
handsets. To display the handset name in
standby mode, turn on the handset name
display feature (page 39).
1
MMENUN#104
2
Enter the desired name (10 characters
max.). a MSAVEN a MOFFN
Displaying the handset name
You can select whether or not the handset
name is displayed in standby mode. The
default setting is "Off".
1
MMENUN#105
For assistance, please visit https://shop.panasonic.com/support
TGD81x_83x(en)_0316_ver222.pdf
2

Registering a unit

Operating additional units
Additional handsets
Up to 6 handsets can be registered to the
base unit.
Important:
R See page 5 for information on the available
model.
Registering a handset to the
base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
is not registered to the base unit, re-register
the handset.
1
2
3
Deregistering a handset
A handset can cancel its own registration to
the base unit, or other handsets registered to
the same base unit. This allows the handset to
end its wireless connection with the system.
1
2
3
39
Programming
MbN: Select the desired setting. a
MSAVEN a MOFFN
Handset:
MMENUN#130
Base unit:
Press and hold MLOCATORN for about 5
seconds.
R If all registered handsets start ringing,
press MLOCATORN again to stop, then
repeat this step.
Handset:
Press MOKN, then wait until a long beep
sounds.
MMENUN#131
R All handsets registered to the base unit
are displayed.
MbN: Select the handset you want to
cancel. a MSELECTN
MbN: "Yes" a MSELECTN a MOFFN
39
2023/03/16 9:00:34