Table of Contents
Advertisement
Answering the baby monitor
n When monitoring with a unit:
Handset: Press M
N to answer a call.
Base unit: Press MZN to answer a call.
If you want to respond from the monitoring
unit, press MMUTEN.
R The monitoring unit will answer calls
automatically when the auto intercom
feature is set to "On" (page 30).
Note:
R If you receive an outside call when
communicating with the monitored
handset, the interrupt tone sounds.
– To answer the call with the handset,
press MOFFN, then press M
– To answer the call with the base unit,
press MZN 3 times.
*1
If MMUTEN is pressed, press MZN 2
times.
n When monitoring from an outside line:
Answer the call.
If you want to respond from your monitoring
phone, press #1 using tone dialling.
You can turn off the baby monitor feature
by pressing #0.
Note:
R The unit disconnects the call
automatically after 2 minutes.
Other programming
Changing the handset name
The default handset name is "Handset 1" to
"Handset 6". You can customize the name
of each handset ("Bob", "Kitchen", etc.). This is
useful when you make intercom calls between
handsets. To display the handset name in
standby mode, turn on the handset name
display feature (page 51).
Handset
1
MMENUN#104
2
Enter the desired name (10 characters
max.).
3
Displaying the handset name
You can select whether or not the handset
name is displayed in standby mode. The
default setting is "Off".
Handset
1
2
Changing the unit's region
N.
setting/Resetting the base unit
1
*1
2
3
Note:
R Changing the unit's region setting may
cause the settings for your country or your
customised settings to return to their default
settings.
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to the
base unit.
Important:
R See page 4 for information on the available
model.
Registering a handset to the
base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
Programming
MSAVEN a MOFFN
MMENUN#105
MbN: Select the desired setting. a
MSAVEN a MOFFN
MMENUN#136
MbN: Select the desired country. a
MSELECTN
"Australia" = Australia
"NewZealand" = New Zealand
MbN: "Yes" a MSELECTN a MOFFN
51
Advertisement
Table of Contents
