Panasonic KX-TGM470C Operating Instructions Manual page 68

Useful Information
Answering system
Problem
The unit does not record new
messages.
I cannot operate the answering
system remotely.
The unit does not emit the
specified number of rings.
Voicemail
Problem
"Voicemail msg. via
phone co." is shown on the
handset display.
How do I remove this message
from the display?
For assistance, visit www.panasonic.ca/english/support
68
TGM470_490C(en)_0805_ver403.pdf
Cause/solution
R The answering system is turned off. Turn it on (page 54).
R The message memory is full. Erase unnecessary
messages (page 55, 56).
R The recording time is set to "Greeting only". Change
the setting (page 59).
R Your phone service provider's voicemail service may be
answering your calls before the unit's answering system
can answer your calls. Change the unit's number of rings
setting (page 59) to a lower value, or contact your phone
service provider.
R The answering system will not answer incoming calls
while the other devices such as handsets are engaged in
a call.
R The remote access code is not set. Set the remote
access code (page 58).
R You are entering the wrong remote access code. If you
have forgotten your remote access code, enter the
remote access code setting to check your current code
(page 58).
R The answering system is turned off. Turn it on (page 58).
R If the first ring is turned off ("No") (page 37), the number
of rings decreases by 1 from the specified number of
rings.
Cause/solution
R This notification is displayed when your phone service
provider's voicemail service (not the unit's answering
system) has recorded a message for you. Typically you
can remove this notification from the display by listening
to the message. To listen to the message, dial the
voicemail number provided by your phone service
provider (for most cases, this will be your own phone
number), and follow the voice instructions. Depending on
your phone service provider, you may need to remove all
messages from your voice mailbox to remove the
notification. You can also remove this notification by
pressing and holding # until the unit beeps.
68 2021/08/05 10:23:31