Transferring Files From The Ck1 To A Pc - Intermec CK1 User Manual

Chapter 5 — Managing the CK1
24 Load your applications. For help see "Loading Applications
and Files on the CK1" on page 47.
The firmware has been upgraded, and the CK1 is ready for use.
If you have any problems, see "Problems After Loading
Firmware" on page 125.

Transferring Files From the CK1 to a PC

1 Configure the CK1 to communicate through a PPP
connection with your PC. For help, see "Configuring PPP
Communications" on page 61.
2 Connect the serial dock (P/N 073665) to your PC and to AC
power. For help, see the quick start guide that shipped with
the dock.
3 Place the CK1 in the serial dock, and turn on the CK1.
4 On your PC, open HyperTerminal and connect to the CK1
using WinSock over TCP/IP. All other settings are configured
through the PPP connection.
5 In HyperTerminal, type
file that you want to transfer, and press Enter. The file is
loaded on your PC.
6 Disconnect from the CK1 and exit HyperTerminal.
118
where filename is the
sz filename
CK1 Handheld Computer User's Manual