AAMP Global PAC SR-GM14H Manual page 8

SR-GM14H
Section 2: In-Vehicle Harness Connections and Preparation (cont.)
Part Two: Factory Rear Camera Retention Harness (CAM-GM51-HAR)
If the vehicle is equipped with IO4, IO5 or IO6 radio AND a factory rear camera, follow the steps below to
install the factory camera retention harness behind the glove box. For IO3 and IOB vehicles, or no factory
rear camera, proceed to Part Four.
Step 1
Plug the gray 12 pin camera
harness from the HMI module into
the CAM-GM51-HAR.
Part Three: Steering Wheel Control (SWC) Retention Harness (GM5LIN-SW-HAR)
If the vehicle is equipped with IO4, IO5 or IO6 radio AND steering wheel controls, follow the steps below to
install the SWC retention harness at the steering column. For IO3 and IOB vehicles, or no steering wheel
controls, proceed to Part Four.
Step 1
Locate and unplug the black 10
pin connector located on the
underside of the steering column.
®
Pacific Accessory Corporation
Step 2
Route the yellow RCA end of
the camera cable to the radio
opening. Secure plug and cable
with zip ties.
Step 2
Plug the male connector into the
female end of the GM5LIN-SW-
HAR and plug the GM5LIN-SW-
HAR male end into the female
connector on the steering column.
© 2020 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
Stinger HEIGH10 Radio Replacement Kit
®
for select 2014-2019 Silverado/Sierra Truck
Step 3
Route the camera RCA out of the
left side opening at the rear of the
CD/DVD opening.
Step 3
Secure the T-harness to the factory
wire harness. Route the 50" single
lead from the GM5LIN-SW-HAR to
the radio opening, securing with zip
ties.
Rev: V1
Date: 030121
Page 8