AAMP Global PAC SR-GM14H Manual page 45

Using Factory Radio Brackets:
4C
Radio chassis mounts to the factory brackets in the sub-dash
Display Adjustment & Mounting:
1. Use all 8 kit mounting screws to attach the radio module & plastic mounting bracket assembly to the
factory brackets. (FIG. M)
a. (4x) #10 X 3/8 screws for the bottom locations
b. (4x) M5 X 10 or (4x) M4 X 10 screws for the top locations (radio module).
If factory bracket is thinner than 1mm, add a washer to space the screws out.
New holes in the factory brackets may need
to be drilled for optimal screen position
Note: There are multiple mounting holes on the
plastic mounting bracket to allow adjusting the
mounting depth. You may drill additional holes in
the mounting bracket and/or the factory brackets
to align the display in the best position and
ensure you can use all 8 mounting screws.
2. Install the assembly (from Step 1) into the
vehicle (using factory screws/bolts).
3. Install the dash kit main frame and any factory
panels that would affect the display installation.
Note: If there is a depth issue with the radio
module in the top position, move it to the bottom
location by inverting the mounting bracket
assembly. (FIG. N)
12
FIG. M
M5 X 10
#10 X 3/8
Factory Bracket
Coarse Thread Screw
FIG. N
4. Attach the display to the mounting bracket
assembly by hooking bottom spring hook and
then pushing up and hooking top hooks. (FIG. O)
5. Determine the desired position of the display:
a. Display can be vertical or tilted up (FIG. P)
b. Display can slide up or down (Page 7)
c. Display can be tilted horizontally (Page 7 – FIG. B)
6. Determine the final front to back position by
measuring the shortest distance between the
display to the dash kit main frame or the factory
dash and subtract that distance/measurement by
~0.25"
Note: Do not push the display all the way up
against the dash. Leave enough bottom gap as
the display's bottom edge rotates towards the
dash.
7. Remove the display from the bracket
assembly by pushing up from compression
spring side (1) and swing out to unhook top (2).
(FIG. Q)
8. Remove the radio module & mounting
bracket assembly from the vehicle. Using
the measurement taken in step 6, install the
radio module & bracket assembly back to that
distance. (New holes in the factory brackets may
need to be drilled).
PROCEED TO STEP 5
on Page 16
FIG. O
HOOK BOTTOM
FIRST, THEN TOP
NOTE: BOOT AND DASH KIT NOT SHOWN
FIG. P
M5 X 10
B
M5 X 10
A
VERTICAL TILT: Use Hole A for no vertical
tilt or Hole B for 8 degrees of vertical tilt.
Insert a M5 X 10 on each side of the clamp
assembly at desired tilt.
FIG. Q
2
1 Compression Spring
4C
13