AAMP Global PAC SR-GM14H Manual page 44

Using a Double DIN Dash Kit:
4B
Radio chassis mounts to the kit brackets in the sub-dash, not to the kit main frame
Display Adjustment & Mounting:
1. Use all 8 kit mounting screws to attach the radio module & plastic mounting bracket assembly to the kit
brackets at the front most location (not to exceed the front of the kit bracket). (FIG. H)
a. (4x) #10 X 3/8 screws for the bottom locations
b. (4x) M5 X 10 or (4x) M4 X 10 screws for the radio module locations (use any combination of screws to
locate the radio in the best position)
Note: There are multiple mounting holes on the
plastic mounting bracket to allow adjustment of the
mounting depth. You may drill additional holes in
the mounting bracket and/or the dash kit brackets to
align the display in the best position and ensure you
can use all 8 mounting screws.
2. Install the assembly (from Step 1) into the vehicle
(using factory screws/bolts).
3. Install the dash kit main frame and any factory
panels that would affect the display installation.
Note: If there is a depth issue with the radio
module in the top position, move it to the bottom
location by inverting the mounting bracket
assembly. (FIG. I)
10
FIG. H
M5 X 10
#10 X 3/8
Coarse Thread Screw
AFTERMARKET
DASH KIT
(NOT INCLUDED)
FIG. I
4. Attach the display to the mounting bracket
assembly by hooking bottom spring hook and
then pushing up and hooking top hooks. (FIG. J)
5. Determine the desired position of the display:
a. Display can be vertical or tilted up (FIG. K)
b. Display can slide up or down (Page 7)
c. Display can be tilted horizontally (Page 7 – FIG. B)
6. Determine the final front to back position by
measuring the shortest distance between the
display to the dash kit main frame or the factory
dash and subtract that distance/measurement by
~0.25"
Note: Do not push the display all the way up
against the dash. Leave enough bottom gap as
the display's bottom edge rotates towards the
dash.
7. Remove the display from the bracket
assembly by pushing up from compression
spring side (1) and swing out to unhook top (2).
(FIG. L)
8. Remove the radio module & mounting
bracket assembly from the vehicle. Using the
measurement taken in step 6, slide the radio
module & bracket assembly back to that
distance.
PROCEED TO STEP 5
on Page 16
FIG. J
HOOK BOTTOM
FIRST, THEN TOP
NOTE: BOOT AND DASH KIT NOT SHOWN
FIG. K
M5 X 10
B
M5 X 10
A
VERTICAL TILT: Use Hole A for no vertical
tilt or Hole B for 8 degrees of vertical tilt.
Insert a M5 X 10 on each side of the clamp
assembly at desired tilt.
FIG. L
2
1 Compression Spring
4B
11