AAMP Global PAC SR-GM14H Manual page 7

SR-GM14H
Section 2: In-Vehicle Harness Connections and Preparation
Part One: Dual USB Extension (SSUSB2)
Apple CarPlay, Android Auto, and any Firmware Updates require access to a USB port. The SSUSB2 is designed to extend the
USB ports on the back of the HEIGH10 to where they are accessible once the radio is installed.
For this installation, the factory 12V power outlet will be replaced with the SSUSB2. You may chose to follow these steps, or
mount the USB port somewhere else in the vehicle. Please note, the factory USB ports will no longer function after the factory
radio is removed.
Step 1
From the backside of the lower
storage compartment, remove the
metal insert from the power outlet
by releasing the two retaining clips
with a small pick and pushing out
the front side.
®
Pacific Accessory Corporation
Step 2
Remove the plastic sleeve by
depressing the two tabs and
pushing out the front.
Step 4
Route the USB cables up and out
of the right side opening at the
rear of the CD/DVD opening.
© 2020 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
Stinger HEIGH10 Radio Replacement Kit
®
for select 2014-2019 Silverado/Sierra Truck
Step 3
Install the optional USB cover and
feed the USB cables through the
front of the panel. Secure with the
flanged nut and then lock with the
lock nut.
Rev: V1
Date: 030121
Page 7