Final Assembly; Wiring & Connections - AAMP Global PAC SR-GM14H Manual

Final Assembly

5
If needed, attach the rubber boot to
the display clamp assembly by aligning
the notch on the top edge as shown,
and hook the boot to the clamp at 5
locations. (FIG. W)
BOOT ASSEMBLY PLASTIC "TAB"
Note: The boot is not required if display
HAS TO GO INTO A NOTCH
(DISPLAY UNIT NOT SHOWN)
sits very close to the dash/dash kit and
no large gap is seen.
6
After all wiring connections are made
in the next section, the dash kit with the
radio chassis and bracket assembly,
should be installed and any factory
panels reinstalled. Connect the 8 Pin
Display Power Harness and the LVDS
Video Cable to the back of the display
and attach display to mounting bracket.
16
BOOT ASSEMBLY PLASTIC "TAB"
HAS TO GO INTO A NOTCH
(DISPLAY UNIT NOT SHOWN)
BOOT ASSEMBLY HOOKS
AT 5 SPOTS
(RUBBER BOOT NOT SHOWN)
FIG. W
Wiring and Connections
BOOT ASSEMBLY HOOKS
AT 5 SPOTS
(RUBBER BOOT NOT SHOWN)
Multi Camera
Power / Speaker
GPS Antenna
USB1 CP/AA
1
15 Amp Fuse
USB2
AV In/Out - Rear Camera Microphone
The top USB1 must be used for
1
Apple CarPlay and Android Auto.
GPS Antenna must be installed for accurate
2
operation of Apple CarPlay, Android Auto &
internal Navigation.
Display Cable
HDMI Input
LVDS Cable
SWI
TOSLINK Radio Antenna
SiriusXM Tuner
17