AAMP Global PAC SR-GM14H Manual page 15

SR-GM14H
Section 5: Radio Unit Installation (cont.)
Part One: In-Vehicle Harness and Cabling Connections (cont.)
Connect the radio side of BAA22
HEIGH10's AM/FM antenna input.
These are the connections for a typical installation. If adding additional cameras,
amplifiers or satellite radio, those connections should be made at this point, before
Part Two: Radio Unit Mounting
Step 1
With the Chime Module and both
display cables routed over the top,
place the RP5 interface on top of
the radio module and slide it into
CD/DVD cavity as noted in Step 2.
®
Pacific Accessory Corporation
1
2
Step 6
Antenna Adapter (1) to the
Plug in the 6 pin SWC / EXT IR
harness (2).
mounting the radio module.
The plastic panel in front of the
CD/DVD cavity is narrower than
the cavity itself and will prevent
the side bracket screws from
passing. The side bracket screws
will need be angled up and over
this panel as it is put in place.
© 2020 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
Stinger HEIGH10 Radio Replacement Kit
for select 2014-2019 Silverado/Sierra Truck
Step 7
2018-19 IOB Only: Plug the 20
pin harness that was removed
from the factory display into the
GM5CAM-DIS-HAR.
Step 2
®
Step 3
Once in place, secure the radio
assembly with two 7mm screws.
Zip tie the Chime Module in
a suitable location. Use the
supplied two-sided tape to secure
the RP5 interface to the top of the
radio module.
Rev: V1
Date: 030121
Page 15