AAMP Global PAC SR-GM14H Manual page 16

SR-GM14H
Section 5: Radio Unit Installation (cont.)
Part Two: Radio Unit Mounting (cont.)
Step 4
Plug the two display cables into
the back of the HEIGH10 display.
Re-connect the factory climate
control connector to the climate
controls.
Product Updates (Firmware)
Firmware Updates (RadioPRO)
The RadioPRO PC app will allow you to update the interface modules with new firmware as it becomes available. Please visit
www.PAC-audio.com/firmware to download available updates.
To update an interface module, open the RadioPRO PC app, connect the interface to your PC via a micro USB cable, and select
"Firmware" and then "Update Firmware".
Now, select "Select File". Finally, browse to the place where you saved the file, and select it. This will begin the updating
process. Once finished, disconnect the interface from the PC.
Firmware Updates (Stinger Radio and PAC Application APK)
To update the HEIGH10 radio firmware and PAC Application APK firmware, refer to the HEIGH10 product page:
www.stingerelectronics.com/products/heigh10
®
Pacific Accessory Corporation
Step 5
Place the mounting panel in place
and temporarily secure it with two
7mm screws.
© 2020 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
Stinger HEIGH10 Radio Replacement Kit
®
for select 2014-2019 Silverado/Sierra Truck
Before reassembly, it is
recommended to power up the radio
and check the chime volume* and
all other functionality...
Volume, Balance, Fade
AM/FM Reception
Bluetooth
USB
Apple Carplay
Android Auto
Camera(s)
* The Chime Module has a 4
position volume selector on the
side. Setting 1 being the loudest
and 4 being the quietest.
Rev: V1
Date: 030121
Page 16