Removing A Dimm - HP ProLiant DL585 Maintenance And Service Manual

Figure 16 Four DIMM slots
Table 5 Processor memory board memory banks with four DIMM slots
Slot
5–6
7–8

Removing a DIMM

1. Power down the server. See "Powering down the server" earlier in this chapter.
2. Extend the server from the rack. See "Extending the server from the rack" earlier in this chapter.
3. Remove the access panel. See "Removing the access panel" earlier in this chapter.
4. Remove the processor memory board. See "Processor memory boards" earlier in this chapter.
5. Remove the DIMM.
Figure 17 Removing a DIMM
IMPORTANT: Be sure all DIMM retention clips are in the closed/locked position before reinstalling processor
memory board into the system.
Reverse the removal steps to install a DIMM.
All manuals and user guides at all-guides.com
Bank
Bank 1
Bank 2
Removal and replacement procedures 25