Hot-Plug Scsi Hard Drives - HP ProLiant DL585 Maintenance And Service Manual

Table 13
Quickfind diagnostic display LEDs
Item Description
7 I/O power fault
8 Therm trip
9 SCSI interlock
10 Power supply 1
11 Power supply 2
12 Bus error

Hot-plug SCSI hard drives

Figure 56 Hot-plug SCSI hard drive LEDs
Table 14 Hot-plug SCSI hard drive LEDs
Item Description
1 Drive activity
2 Online status
All manuals and user guides at all-guides.com
Status
Off = Normal
On = Attention required
Off = Normal
On = Attention required
Off = Normal
On = Attention required
Off = Normal
On = Attention required
Off = Normal
On = Attention required
Off = Normal
On = Attention required
Status
On = Drive activity
Flashing = High activity on the drive or drive is being configured as part of an array
Off = No drive activity
On = Drive is part of an array and is currently working
Flashing = Online activity
Off = No online activity
Action
A power fault on the system I/O board occurred. If the
problem persists, replace the system I/O board.
The server experienced a thermal shutdown.
If one of the CPU thermal LEDs is amber, that CPU
experienced an overtemperature condition.
Be sure that the processor heatsink is properly attached. For
more information, see Chapter 5, "Troubleshooting."
Be sure that no 1.7-inch DIMMs are installed that prevent
airflow across the processor heatsink.
Be sure that the correct DIMMs (1.2 inches tall) are installed.
Be sure that all fans are installed and working properly.
Be sure that the SCSI backplane is installed properly.
Look at the LEDs on the front of the power supply and take
the appropriate action.
Look at the LEDs on the front of the power supply and take
the appropriate action.
A bus error occurred.
The error might have been caused by one of the adapter
cards on this bus (see amber LEDs for which slots might have
caused the error).
If problem persists, remove or replace one or both of the
cards.
Server component identification 61