Otto Bock 17B23 Instructions For Use Manual page 14

► Prior to thermal treatment, remove all temperature-critical components
(such as plastic parts).
NOTICE
Exposure of the product to unsuitable environmental conditions
Damage, brittleness or destruction due to improper handling
► Avoid storage in condensing ambient humidity.
► Avoid contact with abrasive substances (e.g. sand, dust).
► Do not expose the product to temperatures below -10 °C (14 °F) or
above +60 °C (140 °F) (e.g. sauna, excessive sunlight, drying on a
radiator).
5 Preparing the product for use
Gluing in bars
INFORMATION
Corrosion protection
The side bars and orthotic joints are resistant to corrosion. Fine grinding
and polishing increase corrosion protection. Use sintering powder (e. g.
618T40) for coating.
Combine the orthotic joints with:
Side bars
Lamination bars
Required materials: 636W18 special glue and 636W19 hardener or
636W28 special glue, degreasing cleaner
The bars must be glued in the insertion zones to ensure stability.
1) Clean the connecting surfaces with a degreasing cleaner.
2) Mix the special glue and the hardener.
3) Apply the mixture to the insertion zones.
4) Insert the bars.
5) Secure with the enclosed screws.
6) Allow to cure for at least 4 hours.
INFORMATION: Final bonding strength will be reached after
16 hours.
14
17B38*, 17B39*, 17B40*, 17B41*, 17B84*,
17B85*
17Y128*, 17Y129*