Table of Contents
Advertisement
CHANNEL SPEAKER SETTINGS
SINGLE EDIT
Figure 10. SPEAKER SINGLE CHANNEL EDIT VIEW
NR
DESCRIPTION
Metadata of the active speaker preset.
Remove the speaker preset.
Download the speaker preset file to share it or apply to others channels.
Load a speaker preset file from your computer.
Create a speaker preset from channel dsp data
Load the speaker preset dsp data to the channel dsp
Enable/Disable speaker detection.
Set detection threshold and debounce. The 20 kHz current value has to be lower than the threshold for
"debounce" seconds to trigger an error.
Set 20 kHz pilot tone generator level in dBFS which will be added to the actual output signal of the amplifier.
Shows measured current at 20 kHz (yellow line indicates threshold)
Shows actual speaker detection status.
2021-10-20 | Rev. 3.7.5
WEBPAGE SPEAKER PRESET
CREATE.
WEBPAGE SPEAKER PRESET
MA32/D
Chapter 4. SOFTWARE
4.3. USER INTERFACES
LOAD.
4.3. USER INTERFACES | 40/60
Advertisement
Table of Contents
Need help?
Do you have a question about the MAXX Series and is the answer not in the manual?
Questions and answers