Table of Contents
Advertisement
7.
MAINTENANCE
7.1 SERVICE TYPE
Any maintenance operations requiring opening of machine panels
must be carried out with machine at standstill and
It is forbidden to clean and lubricate moving parts!
"Repairs to the wiring, mechanical, air supply or cooling systems, or to parts of same must be
carried out by qualified and authorized personnel and if necessary, according to the routine
and extraordinary maintenance schedules as envisaged by the customer with reference to
specific operation methods, according to the use for which the machine is destined".
Operations necessary for correct machine operation are such that most of routine maintenance
operations are integrated into the production cycle.
Maintenance operations, such as cleaning of parts in contact with the product, replacing of seal,
disassembly of beater assemblies are to be carried out at the end of the working day, so as to speed
up maintenance operations required.
Below is a list of ordinary maintenance operations:
-
Seal cleaning and replacement
Seal must be cleaned at the end of every shift and replaced after visual inspection and when
product is found to be leaking inside drip tray.
-
Beater assemblies cleaning
It must be carried out at the end of each shift.
-
Scraper cleaning
It must be carried out at the end of each shift.
-
Spigot doors cleaning
It must be carried out at the end of each shift.
-
Cleaning of machine panels, tub support and drip tray
To be carried out daily with neutral soap, seeing to it that cleansing solution never reaches
beater unit at its inside.
-
Cleaning and sanitization
At the end of every working day, according to procedures described in section 6 of this manual.
-
Shower cleaning
It must be carried out once a year, according to procedures described in par. 7.4.
Never use abrasive sponges to clean machine and its parts, as you might scratch their
WARNING!
disconnected from the power supply.
WARNING!
surfaces.
- 49 -
Compacta VariO US - 2018/05 - Rev. 01
Compacta VariO US
EN
Advertisement
Table of Contents
