Table of Contents
Advertisement
Compacta VariO US
EN
Compacta VariO US - 2018/05 - Rev. 01
1.2.1 Machine removal from pallet
1- Using a suitable wrench, remove the four screws that fix the two transoms placed between the
pallet and the machine.
Machine removal from the pallet must be carried out by TWO
operators properly trained on required maneuvers. Remove the machine from the pallet
only after having read the instructions below.
2- Place the wooden ramp supplied on the rear side of the machine.
3- Push the machine from the rear side until the two cross bars fall, then remove them laterally.
4- The descent of the machine from the ramp must be guided by TWO operators, one positioned
on the rear side and the other on the front side.
Pay attention that during the movement the machine does not gain speed or
does not block when touching the floor since, in both cases, there is a RISK OF
OVERTURNING with possible personal injury and/or damage to surrounding property.
Fig. 4
WARNING
Fig. 5
WARNING
Fig. 6
- 10 -
Advertisement
Table of Contents
