Table of Contents
Advertisement
6.9 SANITIZATION
Reassemble tub support and drip tray.
During disassembly and reassembly of the tub support,
pay attention to prevent crushing of fingers or hands.
With machine in Stop mode, fill the boiler cylinder with water and sanitizing solution.
Activate the beater by pressing BEATING button (upper part).
After about 30 seconds of beating, pour sanitizing solution in the freezing cylinder
then activate beating by pressing BEATING button (lower part) for a time equal to the section
previously sanitized.
Operating the machine in "BEATING" mode for too long with empty cylinders or just
filled with sanitizing solution brings about a quick wear of the beaters.
Let the solution stay for the time necessary (10-15 minutes), then completely drain sanitizing
solution using handles 5 and 502.
Note:
It is necessary to rinse with fresh and sterile water before finally starting the machine.
Do not touch the sanitized parts with hands, napkins, or else.
6.10 HYGIENE
Fat contents of ice cream and other products are ideal fields for proliferation of mildew and bacteria.
To eliminate them, parts in contact with the product must be thoroughly washed and cleaned as
specified above.
Stainless steel materials as well as plastic and rubber ones used for the construction of these parts
and their particular design make cleaning easy, but cannot prevent the growth of mildew etc., if
not properly cleaned.
It is necessary to rinse with fresh and sterile water before
WARNING!
WARNING
WARNING!
WARNING!
finally starting the machine.
- 47 -
Compacta VariO US - 2018/05 - Rev. 01
Compacta VariO US
EN
Advertisement
Table of Contents
