Table of Contents
Advertisement
4.2.3 Operator functions
BOILER section (upper part)
The upper part of the machine concerns the boiler and the relevant messages are displayed on
the first line.
STOP button
The upper part of the machine is stopped in this mode.
From this position it is possible to access the other functions of boiler section (upper part).
STOP has priority over any other upper part function.
The display will read
11:15:08 MON
HEATING button
This button selects the cycle to carry out.
Once the button is pressed, the display shows the cycle that can be modified using
Increase and Decrease buttons, which can be either:
HEATING+90
HEATING+85
HEATING+65
Free heating
After 3 seconds, by pressing Heating button, the display indicates the charge that
can be modified using Increase and Decrease buttons, which can be:
Max. Charge
Med. Charge
Compacta 4
Min. Charge
Extramin Charge
Then the relevant cycle will start after about 2" or by pressing Heating button.
before enabling any boiler cycle, ensure that there is mix inside the cylinder, or
sensors TER1-2-3 could get damaged and heating elements could get burnt.
The display (first line) shows the temperature of the product in the boiler cylinder
on the left and the set target temperature on the right.
The display will read:
+20
The ramp refers to the temperature that increases.
By pressing Heating again, the set temperature on the right becomes editable and
Increase/Decrease LEDs turn on. Then, it is possible to edit the Heating temperature
value, by using Increase and Decrease buttons.
Press Heating again to quit "heating temp. edit" mode or wait for 10" without pressing
any button (in this way the temperature value is no longer blinking and Increase/
Decrease LEDs turn off).
The edited temperature value is saved when you exit the function.
WARNING
Compacta VariO US - 2018/05 - Rev. 01
- 23 -
Compacta VariO US
+85
EN
Advertisement
Table of Contents
