Yamaha MM700A Manual page 244

c. Clean the spindle and trailing arm bushings thor-
oughly of all old grease.
fore installation.
marks (Figure 6) and install the steering arm (C,
Figure 7).
h. Using a hand-operated grease gun inject grease into
the fitting on the spindle housing.
ment as described in this chapter.
Inspection
1. Clean all components thoroughly in solvent. Remove
all dirt and other residue from all surfaces.
NOTE
during cleaning, touch up these areas as re-
quired before installation.
56 N*m (40
from the steering arm
2. Cheek the steering arm (Figure 10) for cracks, cxces-
sive wear or other damage. Check the splines for damage.
Check the mating splines on spindle.
3. Check the spindle for cracks or other damage.
4. Check the spindle bushing for cracks, deep scoring or
excessive wear.
5. Replace worn or damaged parts as required.
Trailing Arm
Refer to Figure 5.
CHAPTER THIRTEEN