Yamaha MM700A Manual page 204

198
Reassembly
shims into the sliding sheave half.
2. Install the stopper (Figure 43) onto the fixed sheave
half.
3. If the bushings were removed, install them into the
sliding sheave and spring seatkam.
4. Install the sliding sheave half' into the fixed sheave
half.
a. Note the numbered holes on the fixed sheave half
(Figure 48) and the spring seat/eam (Figure 49).
(Figure 44) and
ter. Also perform the Drive Belt Alignment and Drive Belt
Height A4ustmetzt procedures described in this chapter.
b. Refer to Table 17 and install the spring into the
fixed sheave halfby inserting the spring end into the
numbered hole specified.
onto the spring so the spring end resides in the num-
bered hole specified.
sheave half at the specified angle listed in Table 17.
The studs on the sliding sheave half should align
with the bolt holes in the spring seatlcam.
the studs and install the retaining nuts (B). Tighten
the nuts to 23 N*m (204 in.-lb.).
CHAPTER TEN