Front Axle - Yamaha MM700A Manual

226
4. Loosen the jackshaft bearing lock collar setscrews
Figure 35).
5. Remove the nuts, washers and bolts securing the bear-
ing flanges to the bulkhead
the bearing and flange assembly.
Remove the jackshaft.
6.
Inspection
1. Clean the jackshaft in solvent and thoroughly dry.
2. Check the jackshaft for bending.
3. Turn the bearing and check for excessive wear or
roughness. Replace the bearing if worn or damaged.
damage.
5. Inspect the splines for excessive wear and damage.
6. Check both ends of the jackshaft for cracks, deep scar-
ing or excessive wear.
7. If there is any doubt as to the condition of the jackshaft,
repair or replace it.
Installation
3. Tighten the bearing flange nuts securely.
4. Tighten the bearing collar setscrews securely.
5. Install the snap ring (B, Figure
6. Install the brake disc as described in Chapter Eleven.
7. Install the secondary sheave as described in Chapter
Ten.

FRONT AXLE

Removal
this chapter.
(A,
Figure 351, then remove
34) and washer
CHAPTER TWELVE