Assembling The Manual Starter - Yamaha F15B Service Manual

POWR

Assembling the manual starter

1. Install the starter rope 1 into the sheave
drum 2.
2. Check the drive pawl for cracks or dam-
age. Replace if necessary
3. Install the drive pawl 3 and springs 4.
4. Install the manual starter handle 5.
2 3
4
a
NOTE:
9 Tie a knot at the end of the starter rope as
shown in the illustration.
9 Be sure to leave 5.0–10.0 mm at the end a
of the starter rope.
5. Measure the starter rope length. Replace
if the length is out of specification.
Starter rope length:
1,550–1,750 mm (61.02–68.90 in)
5-13
Power unit
6B450210
5
1
a
6D450130
6. Wind the starter rope 1 twice around the
sheave drum 2 in the direction of the
arrow shown in the illustration.
2
NOTE:
After winding the starter rope around the
sheave drum, install the starter rope in the
notch b.
7. Install the spiral spring 6 into the starter
case.
NOTE:
Bend the outer end c of the spiral spring
onto the cut-out d of the starter case.
8. Install the sheave drum 2 into the starter
case 7.
1
b
1
2
6B450240
c d
6
6D450140
2
A
7
6D450150
6D45F11