Disassembling The Propeller Shaft Assembly; Checking The Propeller Shaft Housing; Checking The Propeller Shaft - Yamaha F15B Service Manual

LOWR
cC
Shimming is required when the reverse
gear, ball bearing, or propeller shaft hous-
ing is replaced.
Disassembling the propeller shaft
assembly
1. Remove the shift plunger 1.
2. Remove the cross pin ring 2, pull out the
cross pin 3, and remove the dog clutch
4.
3. Pull out the spring 5.
2
4
1
3

Checking the propeller shaft

housing
1. Clean the propeller shaft housing and
check it for cracks, corrosion, or damage.
Replace if necessary.
2. Check the teeth and dogs of the reverse
gear for cracks or wear. Replace the gear
if necessary.
6-11
Lower unit
5
6B460190
Checking the propeller shaft
1. Check the propeller shaft for bends or
wear. Replace if necessary.
2. Measure the propeller shaft run-out.
Run-out limit: 0.05 mm (0.0020 in)
3. Check the dog clutch for breakage or
wear. Replace if necessary.
6B460200
6B460210
6D45F11