LOWR
Installing the drive shaft
1. Install the drive shaft sleeve, shift rod,
new gasket, bearing housing assembly,
forward gear, drive shaft, shim, thrust
bearing, and pinion gear.
cC
9 Shimming is required when the drive
shaft housing or the drive shaft is
replaced.
9 Shimming is required when the thrust
bearing is replaced.
NOTE:
Install the drive shaft by lifting it up slightly,
then aligning its splines with the pinion gear.
2. Tighten the pinion nut.
6-19
Lower unit
6D460170
1
6B460380
Drive shaft holder 1 1:
90890-06515
Pinion nut:
25 N·m (2.5 kgf·m, 18 ft·lb)
Installing the propeller shaft
housing
1. Install the propeller shaft assembly.
G
2. Install the shim(s) and propeller shaft
housing assembly.
3. Install the washer and propeller housing ,
then tighten the bolts.
Propeller housing bolt:
8 N·m (0.8 kgf·m, 5.8 ft·lb)
6B460390
6B460410
6D460180
6D45F11