Assembling the propeller shaft
assembly
1. Insert the spring 1.
2. Install the dog clutch 2 so that the "F"
mark faces the forward gear, and insert
the cross pin 3.
3
4
5
3. Install the cross pin ring 4 and shift
plunger 5.
Assembling the propeller shaft
housing
1. Install a new needle bearing into the pro-
peller shaft housing to the specified
depth using a press.
1
2
a
Driver rod SS 1:
90890-06604
Needle bearing attachment 2:
90890-06616
Installation depth a :
0 mm (0 in)
6D45F11
2
1
6B460230
6B460150
Propeller shaft housing
2. Install new oil seals into the propeller
shaft housing to the specified depth.
4
3
b
NOTE:
First, install the inner oil seal halfway into the
propeller shaft housing, and then install the
outer oil seal to the specified depth.
Needle bearing attachment 3:
90890-06613
Driver rod SS 4:
90890-06604
Installation depth b:
3.0–3.5 mm (0.1181–0.1378 in)
3. Install the ball bearing into the propeller
shaft housing.
6
Ball bearing attachment 5:
90890-06632
Driver rod LS 6:
90890-06606
6B460160
5
6D460080
6-12
1
2
3
4
5
6
7
8
9